- 分享
- 0
- 人气
- 0
- 主题
- 3
- 帖子
- 484
- UID
- 102107
- 积分
- 550
- 阅读权限
- 17
- 注册时间
- 2007-9-29
- 最后登录
- 2012-6-15
- 在线时间
- 497 小时
      
|
本帖最后由 garytan 于 2012-6-15 03:43 PM 编辑
回复 2# 叛逆志文
请问要怎么知道modem内的DNS是不是填错~?
Example: Changing DNS server settings on MicrosoftWindows 7- Go the Control Panel.
- Click Network and Internet, then Networkand Sharing Center, and click Change adapter settings.
- Select the connection for which you want to configureGoogle Public DNS. For example:
- To change the settings for an Ethernet connection,right-click Local Area Connection, andclick Properties.
- To change the settings for a wireless connection,right-click Wireless Network Connection, and click Properties.
If you are prompted for an administrator password or confirmation, typethe password or provideconfirmation. - Select the Networking tab. Under Thisconnection uses the following items, select InternetProtocol Version 4 (TCP/IPv4) or Internet Protocol Version 6 (TCP/IPv6)and then click Properties.
- Click Advanced and select the DNStab. If there are any DNS server IP addresses listed there, write themdown for future reference, and remove them from this window.
- Click OK.
- Select Use the following DNS server addresses.If there are any IPaddresses listed in the Preferred DNS server or AlternateDNS server, write them down for future reference.
- Replace those addresses with the IP addresses of the GoogleDNSservers:
- For IPv4: 8.8.8.8 and/or 8.8.4.4.
- For IPv6: 2001:4860:4860::8888 and/or 2001:4860:4860::8844
- Restart the connection you selected in step 3.
- Test that your setup is working correctly; see Testing your new settingsbelow.
- Repeat the procedure for additional network connections youwant to change.
|
|